Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
You could do that with an Cisco EZ VPN compatible device on the other end. Even though Linksys is now a Cisco product, I'm not sure it supports it yet. The trick is the vpngroup command, which allows you to define multiple vpn groups, each associated...
You say you can't ping 192.168.18.18 from 172.30.0.1 but in reality I think you meant that you can't ping 172.27.18.18, which is later translated to 192.168.18.18 by pix2.Does PIX2 know how to route to 172.30.0.1?
Karen, does that happen when you add something to a pdm group? If so, don't worry about it. Pdm commands only help the PDM software understand the configuration. They have absolutely no effect on the operation of the firewall.Otherwise, please explai...
The only thing that I would recommend to you is to enable and configure the proxy settings on the web browsers of your users. I know, that can be a very tedious task if you don't trust your users to do it themselves. One way to facilitate could be by...
A side note:When the primary fails, the 2 units will swap their IP addresses around. If you try to SSH to the secondary, you will actually land on the primary because of that.
