Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am setting up SNMP v3 on a 9200 below are the commands I am using. When testing I am not getting a response from the switch. When I run an nmap it doesnt show port 161 open.
snmp-server group Test_GROUP v3 privsnmp-server user Test_USER Test_GRO...
My nmap only shows port 22 openPORT STATE SERVICE VERSION22/tcp open ssh Cisco SSH 1.25 (protocol 1.99)SN Snmp119 SNMP packets input0 Bad SNMP version errors45 Unknown community name0 Illegal operation for community name supplied16 Encoding errors0 N...
