According to the Cisco Interop matrixhttp://www.cisco.com/en/US/partner/docs/switches/datacenter/mds9000/interoperability/matrix/Matrix6.html#wp311832you would only be able to connect them by putting the Brocade 300 into NPV(Brocade AG) mode.That sai...
Stephen, Just need to correct your comments regarding AIX.Early versions of AIX did not support FCID changes, and required some manual actions to pick up the change. AIX has though for some time supported 'dynamic Tracking' which allows the FCID to c...
Simply put, a 9124, in any form, when put into NPV mode 'npv enable' is the same function as a Brocade Access Gateway.i.e. Both use NPIV to log multiple WWPN's over a single F port.While implementation of the function may be different, the actual fun...
Hi, I don't really understand why you would avoid upgrading.Cisco have carefully documented a 'workaround' which is so that you can perform the upgrade by following the documented workaround procedure, and therefore not be at risk of the "rare condit...
Richard, you should refer your service provider to BUG ID: CSCsh98705 where it states a Workaround:The workaround to recover the management ethernet port is to power-cycle the switch. The fix for this issue will be available in 3.2(1).So basically...