About btjtaylor1

btjtaylor1 · 10-16-2018

Hi I'm currently building a proof of concept for our firepower implementation and i've run into some confusion regarding NAT and FMC I am testing the following set up: FTD at remote site is behind a single public IP FMC is at the central site b...

btjtaylor1 · 07-16-2018

Hello all I have deployed the Firepower Threat Defense NGFW 6.22 virtual machine to my VMware ESXI 6.0 infrastructure but it's not allowing me to complete the install The VM boots up then asked me to log in, I log in with the default credentials ...

btjtaylor1 · 10-18-2018

Thanks for your help, I guess there's 3 options as I see it, with an internet circuit (as it would be in production, lab was using p2p for simplicity's sake):1 - Install router in front of FTD and use this to NAT the traffic (e.g. Cisco 892 or 861)2 ...

btjtaylor1 · 10-18-2018

Ah ok, I can do that in a lab, but in production i'd need to put a router in front of the FTD? That's disappointing as I was hoping to implement with as little hardware as possible for simplicity and cost savings.

btjtaylor1 · 10-18-2018

Thanks for the replies Please see attached a quick diagram of my lab topology FTD1 is joined to the FMC successfully. I have configured a NAT rule and firewall rule on FTD1 to allow incoming connections to the FMC on FTD1's WAN IP (1.1.1.1) on...

btjtaylor1 · 08-14-2018

I checked all the VM properties (only change was to add a serial port, turn on promiscuous mode on the virtual network) and it still didnt boot up correctly. I reinstalled the VM on an Intel-based VMware host and it worked first time ... not sure w...

Member Since	‎04-04-2018 02:31 AM
Date Last Visited	‎04-21-2021 05:30 AM
Posts	6

User Statistics

User Activity

Connect FTD to FMC with NAT at both sides?

Firepower Threat Defense not booting on ESXI

Re: Connect FTD to FMC with NAT at both sides?

Re: Connect FTD to FMC with NAT at both sides?

Re: Connect FTD to FMC with NAT at both sides?

Re: Firepower Threat Defense not booting on ESXI