Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I loaded the latest PDM bin 4.1(1) for the PIX os ver 6.3(4) but I am getting an error message when I try to access the new PDM:"Cisco PDM 4.0 for FWSM does not work on PIX. Please install Cisco PDM 3.0 on your PIX"Hmmm a Pix Device Manager that does...
Hello,Are there any tricks to watch out for when upgrading a single port Ethernet card in a Pix 515E to a 4 port (4FE-66). We are @ version 6.1(2). We have a VPN accelerator card in one of the slots. The single NIC in the other. When I take that out ...
OK I got the 3.0(2) bin and it looks like the PIX software table omits the 4.x PDM version that was there a couple of days ago.Hmm I can't access the PIX anymore from the console via Hyperterminal. When I try to connect I get, "Unable to open Com1. P...
OK it looks like just writing to mem did the trick. The config specified 0.0.0.0 as the IP where the correct format in version 6.3(4) is w/o an IP designation if there is no failover. so the following is valid:no failover ip address outsideetc...
In 6.1 I had the following failover configs (i have no failover device):no failoverfailover timeout 0:00:00failover poll 15failover ip address outside 0.0.0.0failover ip address inside 0.0.0.0failover ip address DMZ 0.0.0.0These are reported as error...
It turns out that I had to upgrade my software to 6.34 to get the PIX OS to recognize the hardware. This involved setting up a TFTP server (Windows 2003 has one and you can find some VB scripts ont he net for turning them on and setting the root dire...
