Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Our Pix (535 6.3(1) UR Licence) sometimes do not seem to advertise a physical interface's mac address to the Cisco 6509 switch where the dot1.q trunk terminates.With one vlan it works fine, with another vlan it does not.Clear arp in both Pix and s...
Hi all.BRIEF DESRCIPTION OF MY PROBLEM:We have earlier successfully configured vlan trunking (dot1.q) on a PIX interface with one vlan on physical interface and two vlans on logical IF's under same physical IF. (As in following dokument: http://www.c...
"Why dont' you hard code the MAC entries on the CAT switch?"Yes, thats a very good question. It would probably solve the issue too even if I still think it's a little mysterous why I would need to do it.Insufficient knowledge and lack of imagination ...
