Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys,
Could you please help me to make it clear why it is happen?
So I have a Cisco ASA 5506-X with Software Version 9.8(2) in live service.
The inside interface sec-level is 100 and the outside is 0.
On inside there is only one rule :
access...
Hello
There is a same it does not work:
FW# ping TCP Ping [n]: Interface: insideTarget IP address: 10.x.x.4Repeat count: [5] Datagram size: [100] Timeout in seconds: [2] Extended commands [n]: Sweep range of sizes [n]: Type escape sequence to abo...
Hello
Thanks for answer i tried as you suggested and here is the output:
FW# packet-tracer input inside icmp 192.168.1.1 8 0 10.x.x.4 detailed
Phase: 1Type: UN-NATSubtype: staticResult: ALLOWConfig:nat (inside,outside) source static LAN 172.x....
