Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How can I redirect a tcp/udp port through a CSS ??? I have an application running on VLAN2 and it needs to connect to a server running on VLAN3. This application first go to a vip address in the CSS, and this vip is balancing the service across TCP p...
HelloI had similar problems, and I also had to call to Cisco License, as the last post said. It is very important to write the right MAC addresses of the CAM server (interface eth0) and if you're managing servers with HA, also send the MAC address of...
HelloI?m not an expert, but I'm installing a NAC appliance too, 1) You must map each one CAM to a DNS for resolve locally the CAM name, using eth0 , also the service ip address.2) What kind of failure ? The certificate is generate to keep the comuni...
Actually I have the same problem and a ticket opened with the TAC. The enginner assigned toll me that Nortel Contivity 1700 has two types of mode Main and Agressive. So I should be sure the mode that is configured on Nortel is Main and not Agressive....
Partially, yes.The problem is that the some servers are in the DMZ, before the firewall and attached to one CSS, and the other servers are in the inside, attached to other CSS. We are doing the firewall load balancing between CSS.
