Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI,Pls suggest me how to to do the following tests in FTD (Case 1)Test Item -Detect Land AttackTest procedure /Reference - Same Source IP/port to destination IP/Port to be generated on the outside interfaceExpected result - Deny traffic should be sh...
Hi, I have Firepower [FTD] in HA, Both the Firepower devices are connected to Nexus (93180 FX).I have configured BGP between Switches and and Firepower,While doing Firepower switchover or switch failover ( Shutting down on switch] , we observed that...
HI, I have Firepower (FTD) in HA managed through a standalone FMC, There is a peculiar issue, Whenever my Primary unit is active and I deploy , I get the error " Deployment failed due to communication Error", So I have to switch over to secondary u...
HI,It's taking long time in active/standby FTD switchover,Is there any mechanism to minimize the fail-over time or is there any config required? Primary Unit to Secondary unit - it takes 5-6 seconds Secondary Unit to Primary unit - it takes 10-11 se...
Dear All,I have a standalone FMC managing 2 FTDs in HA, Recently I observed that Primary unit is showing disabled and secondary take on as active. During trouble shooting,It is found that I could not ping Manager(FMC) from primary unit [FTD]I could s...
HI, The logical device is created on 9300 pair,over which FTD security module is used. FMC(Standalone) is managing FTDs.I am doing firewall switchover through FMC, BRBibek
HI, Thanks for sharing your experience, Actually the configuration swiped out from my Primary unit [ I don't know the reason] and everything is working on Secondary Unit The failover-link , State link-link and Data ports are showing Status " admin do...
Thanks for your help, I have reimaged the FMC and add the FTDs in HA, Now the issue is different, I could do deployment when Secondary unit is active but could not deploy when Primary unit is active. Have anyone seen such issues ? BRBibek
Hi, I tried with TAC but it is not happening , Since I cannot provide remote access due to some security reasons, I have to do it of my own, Can you let me know the process/Challenges to reconfigure FMC , FTDs are in HA 1.What will happen if I...
