Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm running into an issue where we have an older Cisco ASA 5505. Needless to say, it's quite old and we want to replace it with a newer Cisco ASA 5585.
This ASA has been on the shelf for a couple of years so I'm pretty rusty with the Cisco stuff an...
Ok, so if I understand this correctly, i think all the old exempt rules were doing was a NAT from the IP's in the "city" list" to the specific interface, either "city" or "kps".
I'm going to go ahead and do a PAT on the 5585 and I'll mark Rahul's re...
Ok, Thanks for the link and information.. I checked the document in the link but I guess I'm not clear on what this statement on the ASA 5505 is actually doing?:
nat (city) 0 access-list city_nat0_outbound
If I run the command "show NAT city" on ...
Ok, So I logged into the 5505 via the ASDM, and I see this in the NAT rules:
Spoiler
So I looked in the interfaces and I'm not seeing this outbound interface:
So I guess I'm wondering if this is needed on the 5585 ASA? it appears that it is ex...
