Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,some time ago I implemented a basic parent/child command line QOS policy to help police our internet bandwidth as such: (i've only included the inbound policy details, there is also an outbound policy applied)policy-map site_inbound_internet_bandw...
I currently have a checkpoint firewall, connected to an aggregation switch, and then a 2nd switch uplinked to the aggregation switch. The firewall acts as the layer 3 default gateway for all vlans, and there is a trunk carrying multiple vlans to the ...
I use embedded QOS with shaping at a parent level and bandwidth statements at a child level, on both the inbound and outbound interfaces of a router. I am seeing lots of output drops on the inbound interface (inbound to LAN). However I am seeing this...
Can anyone help explain why a host in one isolated vlan is able to ping another host in a different isolated vlan when using the following configuration?vlan 500 name pvlan_test_1 private-vlan primary private-vlan association 600!vlan 501 name pvla...
Hi - I have a router configured with ATM IMA & 3 X ATM 2Mbps circuits which never reaches it's max 6Mbps bandwidth. I fully understand about IMA & ATM overhead and that I should not reach 6Mbps however I am only reaching 4.6Mbps. The router does have...
Hi there - thanks for your response. I'm not sure I was very clear. If I add the more specific staetment in then the child policy would look like this:policy-map site_inbound_internet_bandwidthclass Customer_specific_server police 3000000class Cust...
Hi - thanks for your response. Maybe I wasn't clear enough, this is not yet implemented, and it's not that I'm having problems, yet. When it's configured they will be in transparent mode yes, and the other standard pvlan config will be applied. My qu...
Hi Kevin - thanks for your response.The class-default is not a class as such rather a requirement to create the parent shaping policy. My example is probably a bad example as this is an internet circuit and an inbound filter filters all traffic not d...
I am using MRTG & a Netflow application level server to measure the throughput. Maybe I have my calculations wrong, and I am no ATM expert (hence this post) but I was expecting a greater throughput.
