Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an old computer running pfsense, talked boss in buying an applicance. My concerns regarding the ASA 5505 is that it is older, and EOL could be announced at any time. And, the fact that AIP SSC has already been announced to be EOL, or End Of ...
How can I release DHCP on external interface? It has obtained an IP from ISP that they have decided don't want me to have, so have to release address so can obtain a new IP. I keep getting the same IP back.
new ASA 5505, tying to configure it, inside LAN is 192.168.2.x/23 (255.255.254.0). I connect to ASA5505 using ASDM ok when it is on the default 192.168.1.1. I change the ip on 'inside' vlan, and of course lose connection to it. It apparently doesn't ...
Thanks, I double checked with my ISP, and they had not removed an earlier test computer's MAC address that I had setup (to try and resolve another issue), so in effect there were two MAC address bound. The ISP removed the old MAC address, which cured...
Thanks, I set to static, and gave it the 'new' IP (x.x.x.40, (using ASDM), save, then set back to DHCP, but it always grabs the 'old' IP (x.x.x.241). The ISP is reserving x.x.x.40 for this MAC address, another possible problem is that I didn't set th...
thanks, that did the trick. Can't you set that in ASDM? I'd hate to have to do that whenever I change the internal IP (just trying to learn it right now, not in service yet).Steve
Wasn't aware needed to give the IP address access, but have done so now. Ok now.basic question on security, since you mentioned it, why is the default "outside" level 0, isn't the lowest security? Shouldn't it be 100?Thanks, Steve
