Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to add an identity source and fill in all the fields. But the test failed:"Cannot connect to realm for Identity policies. Message returned: The connection test failed with an unknown error."Domain controller is available from FirePower, t...
Hi,I've the FirePower1010 versions 6.5.0.2.There are several interfaces:- Ethernet 1/2 with address 192.168.24.245 and is belong by inside_zone- Ethernet 1/4 with address 192.168.23.245 and is belong by video_zone But I cann't ping 192.168.23.245 fro...
The identity policy settings are in attachment sreen. AD Identity Source is Identity Realm (AD) How can I mapping users to IPs? Actually, I need to use access control rule and implement it by group of domain users and see the activity domain users in...
I created the policy in access control: Source Zone - Inside zone, Destination Zone - Outside Zone, Users - "name_of_Identity\test_group_users".But there are no hits in this policy.And reason is added users in policy. Without users the policy is work...
@Aref Alsouqi wrote:Did you test the policy? or you just tried the configuration test? I've seen a few times the test failing but actually the connectivity between the AD the and device is working.Yes, I tried to add the group of domain users in poli...
Domain controller is able from Management Interface firepower.There is not ip adress on the diagnostic interface but it is up and mode is routed.I use Device manager to configure firepower and this menu doesn't exist: "Firepower MGMT -> Switch -> DC....
