Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Working with a lab 5506-x and c3560cx and throwing some OSPF at it to see what sticks. I want the ASA to route to the internet, but I have three Vlans on the switch with SVIs for each subnet. I have NAT working on the ASA out to the internet, but on...
I have a request from on high to monitor existing ASA firewalls using only ASDM. The need I have is to be able to monitor multiple devices for a variety of reasons --- from interface traffic to VPN sessions, etc. I've been using snmp regularly to g...
"lab 5506-x and c3560cx" Thanks, I was aware of the IPBase limitation already, although it's odd that I can actually do OSPF with15.2(6)E1 even though the notes say it's not supported.
The part I left out is that eventually I want to add a second switch to peer with the first switch and have another router connected to the second switch to allow another gateway. I would have the same subnets across both switches and use OSPF across...
I'm familiar with that setup, and I've done that before. But in this lab scenario, I was wondering if I could OSPF to help advertise multiple gateways for multiple subnets coming from the switch. Changing over to a routed port would be easy, but it ...
That's pretty much what I was thinking --- limitations on how many instances I can run, actual historical information on a device, setting up the GUI each time to graph and chart what I need to see... etc.
When I can setup an snmp server and start g...
