Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two ASA 5525X in a High Availability (Active/Standby) configuration both running Firepower services licensed on both for IPS, AMP, & URL. I'm managing both ASA FTD's through a virtual FMC. My question is: Do I also need to configure the High A...
I've cleared the service-policy counters on both (Primary & Standby ASA's) You can see from the output below that the packet input & output is incrementing up from the # show service-policy global sfr on the Primary (Active ASA). You can also see fro...
I've ran the Show Network command in the SFR Console of the Standby ASA and everything looks normal. ======================[ eth0 ]======================State : EnabledLink : UpChannels : Management & EventsMode : Non-AutonegotiationMDI/MDIX : Auto/M...
That’s what I was looking for, thanks for clarifying this for me. One last question if you don’t mind, I just wanted to verify this if I may? With the HA configured in the ASA code (Active/Standby) how I currently have it setup, my Standby unit shows...
