Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Can anyone help me?!I’ve had an ASA5510 up and running for some time without any issues.I recently purchased a ASA-SSM-AIP-10-K9 card to learn with.When I received the card, when doing a Show module 1, I could see that there was no firmware on the...
@Marius Gunnerud Hi Marius,Thanks again for the information!I tried what you suggested a few ways, but with no luck. I also tried it the simplest way I could, given the information you kindly provided :-My PC with the static IP address of 192.168.2....
Hi Marius,Thanks again for getting back to me.I had previously read this document a number of times, but I'm still a little confused..."Make sure you can access the TFTP server location from the network connected to the Ethernet port of the adaptive ...
Hi Marius,Thanks again for the suggestion. I've physically connected the SSM-AIP management port, the ASA Inside port and my PC to a flat switch.I'm using Tftpd64 as the file server on the PC. Via "HW-Module Module 1 recover configure"I've set the tf...
Hi Marius,Thanks for sticking with me.With the commandhw-module module slot recover bootthe slot refers to the slot number where the SSM-AIP card is.In my case, it is in slot 1. So, for me, the full command is :-hw-module module 1 recover bootWhen I...
Hi Marius,Thanks for the reply. To be honest, I've tried going direct from the PC (and so the tftp server) direct to the management port on the SSM, I've also tried to go PC -> Switch -> SSM Management port.Am I correct in thinking this is the correc...
