Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has any one seen an issue where you re-image a 5508-x with a known good copy FTD 6.2.3. You use the same IP for the managment NIC for TFTP and HTTP to install the image. Once FirePower is on the device you can not communicate to or from the managment...
I found the solution. The config register was set to 0x41 and should have been set to 0x1.
To fix I booted to rommon and executed the confreg command with showed the Current Configuration Register: 0x00000041
I issued the command: confreg 0x1
t...
Thanks. Yes - different cables, different switch ports and even different switches. It is only FTD that is causing the issue. I re-imaged with ASA software and installed the SFR module and everything works great.
I have tried 3 different versions o...
That is correct. FTD can not ping the local gateway or anything else on the local network after FTD has been successfully installed. Funny you mentioned IPtables - I checked the status of IPtables and everything looked identical to my other 5508. I ...
