Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Afternoon,We have received this error on a switch which resulted in 5 ports being dropped.2010 Apr 28 20:45:32 Switch144 %KERN-2-SYSTEM_MSG: mts_do_msg_input() failing since no space available in 22 (src_sap = 22, opc = 709)2010 Apr 28 20:45:32 Switc...
We have purchased 4 X 9124s over the past 6 months. 3 of the switches after short use lost their ethernet ports. Power cycling etc will not get the ports working. I keep sending them back for replacement but now the replacement units are also failing...
We currently have all traps sent to a specific IP address but getting inconsistencies. Is there a command in the CLI to view the outgoing traps or a list of traps sent? CheersRichard
What do people use for monitoring / login switch information to help with faults etc.Our SAN has now grown to about 70 switches 50/50 brocade / cisco. (time we started keeping an eye on it)
Yeah I was thinking of that or just route it out over the mangement port of another switch via FCIP.Ill have a crack at that and see if the latest firmware fix's it.Cheers
Completely removed power from the unit. Tried leaving them powered off over night and trying in the morning but no joy. The 2 lights on the ethernet port flick for about a second on bootup then remain dead. If you console into the switch apparently t...
Unfortunatley a reboot of the switch doesn't bring the port back, it doesn't even get a link light!It stinks of a hardware fault but I carn't believe iv had 4 straight failures.
