Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Not being too familiar with the ASA, I have everything configured I need and it is working. The problem now is, I am trying to get an additional external IP address working to point to a new server inside our network. In many other firewalls and even...
I have setup several PIX firewalls in the past but never had the need to use the new Object-Group configurations. I have a setup that requires me send traffic to multiple internal servers when listening on one of the external IP addresses and using p...
I have tried both of these suggestions, with the same results. Timeout on the outside. I assume these were to be used together and remove the old one which I did correct?
I guess this is what I was trying to avoid.... I figured there was a way to do it for each port needed with a static command, but you are saying there is no way to do this using a group command? So we will have to make an entry for each port required...
Yes, keeping the existing xxx.xxx.xxx.210 as the default external IP and now using the xxx.xxx.xxx.219 soley for these 3 internal IP's using the port ranges as we discussed in earlier posts...object-group service PORTS_150 tcpport-object range 5080 5...
