Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,u need to assign the new adress in corresponding Logical Node Profile of the IPN L3-Out: go to "Tenants -> infra -> Networking -> "IPNL3Out" -> Logical Node Profiles -> "NodeX" and change the loopback adress
Hi @JamesB11 ,Did u already check your discovery mode settings? (can either be "strict" or "permissive")System->Controllers-> APIC1 --> Cluster as Seen By Node regards
I think you´re misunderstanding the function/need of L3 Outs. L3 Outs are dedicated routed interfaces which are (or can be) used to connect routed aci networks & external routers, firewalls,etc.You only need L3 Outs if you plan to migrate SVIs/DGWs ...