Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I have one firepower 2140 security appliance running ASA mode with version 9.8(2).
The device is factory installed with ASA image. And I created three port-channels by separately adding Eth1/1,Eth1/2and Eth1/3,Eth1/4 and Eth1/5,E...
Hi I created a case on the issue and it turned out the LACP problem, below is TAC's reply for your refference: The Firepower 2100 supports EtherChannels in Link Aggregation Control Protocol (LACP) Active or On mode. By default, the LACP mode is set t...
