Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a new cisco ASA 5510 that i have to configure for the first time. After setting my terminal emulator for 9600 baud, 8 data bits, no parity, 1 stop bit, no flow control and connecting the appliance to my Pc with a console cable, i powered it...
I used both crossover and straigh cable to connect to the ASA's management port but, nothing. Also when the appliance in powered on, only the LED located beside the button power behind the device lights. The LED located in the front (power, status,...
Unfortunately, when i connected my PC to the ASA with a crossed cable, the management port of the ASA stayed shutdown. Then i can't connect to it.I noted that there was a reset button behind the ASA. I pressed it longuely after a reboot in the hope ...
I just want to add something, i noted that when i change the speed value from 9600 bauds to 110 or 300 bauds, it seems to write something like a caracter but it doesn't continue.Thanks.
