Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to update my IDSM2 sensor version 4.1(4)S172 to IPS 5.0. I've already downloaded the appropriate file file 5.0(1)S149 major update. But when I enter the commands to upgrade the sensor version, it says:# upgrade ftp://<my ftp ip>/IPS-K9-maj...
My IDS Sensor 4.1 stops capturing events after some time. I don't know if maybe it is because there are a lot of VLANs in SPAN and the IDS doesn't support all this traffic. Am i wrong?Here is the show ver output:># sh verApplication Partition:Cisco S...
I still haven't found the answer... but I wonder if this may be originated by the fact of the ISM2 to try to process too much traffic.I mean, the IDSM2's interfaces are 1 Gbps and the maximum process speed is 600 Mbps. I think this is correct.I'm usi...
I get the same error than you, laneclark. To be concise, it says:Error connecting to sensor. Failed to load sensor-errSystem Error-ct-sensorApp.466 not responding, please check system processes - The connect to the specified lo::ClientPipe failed. Ex...
I get the same error, but only after a short period of time. When this happens, Security Monitor in VMS doesn't show any alarm. I can actually ssh into this IPS 5.0.2 sensor, but typing 'show ver' I realize that 'AnalysisEngine' is "NotRunning". And ...
First of all, thanks for your attention.I have updated to signature S175 (maybe I shouldn't have updated directly to that signature) and still gives me that error message. And I actually think you are right, marcabal, because with this update I get t...
