A previous admin did lots of access-lists with the PDM and created a myriad of ACL's using groups w/descriptions. Problem: When I view my ACL's from the CLI using sh access-list I only get the description on rules using groups and descriptions.Quest...

Okay, two easy Q's for you guy's...#1 .. I created a rule on my 515E using 'access-list' and it shows using 'sh access-list'. However, when using the PDM, I do not see it listed. (I'm a noob)... is this supposed to be the case?#2) .. From the comma...

There seems to be many IP Addresses that AIM uses to login so I had to block a range of IP Addresses in my rules: (64.12.0.0) + (205.188.0.0) along with port 5190 on a separate rule from any 'inside' to any 'outside'.This does seem to work in denying...