Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello to all this is my first post so i would try to keep it simple and clean.
I got 2 internal ip's that i want to translate them to 2 external ip's .Each one on its own.
Lets say x.x.x.10 to x.x.x.200 and x.x.x.11 to x.x.x.201.
Now which concept sh...
mm it make's sense but what i realy want is that the 2 internal ip address translated to the 2 public ip address .Each one on its own the .13 to .13 and .14 to .14 .Can it be done ?.
Now it works with the .13 if i reload the Asa is goes ether to 13 ...
Thank you for you replies and sorry for them late response .
So here is what i got now
object network xxxxx nat (outside,DMZ) static 10.x.x.14object network xxxxx nat (DMZ,outside) dynamic 151.x.x.14object network xxxxx nat (outside,DMZ) static 10...
I am getting that:WARNING: Pool (151.x.x.14) overlap with existing pool.
after doing
show nat pool
i get this results
NAT pool outside:NatPool, range 151.x.x.13-151.x.x.14, allocated 1.
On your previous recommendation the
conf t
object network x...
Thank you for the reply .
Just clarify something since i am not the initial configurator of this ASA and my knowledge to it is limited to a point here is what i got now.
show xlate3 in use, 622 most usedFlags: D - DNS, e - extended, I - identity, ...