Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When you configure SNMP v2, it should not require any further configuration in the Meraki for port 16100. If you are blocking that port outbound and upstream from the device you are doing a walk from, that could be an issue. As for dashboard logs, on...
Do you have any IP restrictions set? If so, remove them and try again. The little example they give you where you set it up should just work when you paste it in a terminal with internet access.snmpwalk -v2c -t 10 -c <COMMUNITYSTRING> -Ob -M +. -m +M...
