Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Guys I am hoping one of you out there have a similar setup to ours, and may have come up with a solution. We currently test that our web sites are up and running with a configuration similar to this:service somesite_home_http1 ip address 192.168.1.2...
Hi guys.I am hoping that one of you might be able to point me in the right direction. I have several IIS based web sites that are using SSL certificates. For the most part these sites only have a folder or two that need to be forced into SSL, which I...
I have currently a CSS 11501 that is configured to use only SSHD on the management interface for remote access.I am also attempting to configure Solarwinds Cirrus for software revision management.The problem that I am running into is that when using ...
All,Can anyone advise on the best way to re-direct entire domains to a new domain?Specifically, our problem is that our original domains are all being retired. As of a certain date, I would like to re-direct every request of *.olddomain.com to a "sor...
All,Please forgive my asking this question again. I was injured shortly after asking the last time and out of work for a long period of time.My problem stems from needing to allow my web servers to initiate traffic to the outside world from behind ou...
Gilles,I ran a test, set the range to 2 and then tried all of the servers again. The first two worked, the third failed.Then I set it up the way you recommended. Thanks and take care.
Gilles,I added the following commands, and things seem to be working.To circuit VLAN1 ip redundant-vip 1 1.1.1.80!*************************** GROUP ***************************group natout vip address 1.1.1.80 add service nat_web_servers activese...
Gilles,Thanks again for the help. I am not "knowingly" using any client NAT in my current config. I am definetly not using any groups.I have the CSS boxes connected to our DMZ network (Circuit VLAN 1 - Public addresses) and to a second "server" net...
