Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I being looking for a solution to get pnp to work with trunking ports.My current config is a upstream router (1941) with a EHWIC-D-8ESG-P and a downstream switch WS-C2960XR-48TS-I.I configured the router as followed:ip dhcp pool PNPnetwork 10.2...
Hi Peng Xu,Thx for the support so far With the install macro on the downstream switch you now create a access port on the connected port to the upstream device. Is there an option you change this to a trunk port? In that case the vlan (from the comm...
Hi Peng Xu,Here is the output requested:interface GigabitEthernet 0/1/6 switchport trunk native vlan 999switchport mode trunkno ip addressROUTER1941#show int G0/1/6 switchportName:Gi0/1/6Administrative mode: trunkAdministrative Trunking Encapsulation...
Adam,That is not a option... Command doesn't exist on the 1941 with EHWIC-D-8ESG-P:ROUTER1941(config)#int G0/1/6ROUTER1941(config-if)#switchport mode ? access Set trunking mode to ACCESS unconditionally dot1q-tunnel Set trunking mod...
Adam,I executed the commands an now the vlan gets created at the 2960 sh cdp tlv appAPP TLV (Gig 0/1/6), Configured tlv type: 4099 value: 1APP TLV (Gig 0/1/6), Configured tlv type: 4103 value: 990Now the vlan exist on the 2960 but he can't get a ip a...
Adam,Thx for the super fast reaction.No the switch stays in vlan 1, receives a ip address + dhcp options and goes from there... 2960 SW Version: 15.2.(2)E61941 Version: 15.6(3)M Stefan
