Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a cisco 1700 router running 12.1(3) that has one Serial interface for a point-to-point T1, and one BRI U interface for a backup ISDN BRI if the serial interface goes down. Here's my running config:Current configuration:!version 12.1service tim...
Hi, I recently purchased a 1720 router on ebay and it arrived without a Serial Number sticker. Does anyone have any ideas on how I can locate the S/N without that sticker?Thanks!
I just wanted to let everyone know that I was able to get this working once I upgraded to 12.2. I had to make some other small config changes, so I'm not sure whether it was those changes or the upgrade that fixed my problem, or even if it was just a...
Thanks for mentioning the missing dialer-list command. Here's what I added in:dialer-list 1 protocol ip permit(that went in on the line above: snmp-server engineID local *****)This is only my second attempt at using dialer lists in a Cisco ever. Can ...
Maybe I wasn't clear enough in my earlier explanations... Layer 1 is deactivated b/c the BRI Int is in backup mode which essentially means it is shut down. It shouldn't turn on until the Serial Interface goes offline. Hence the Layer 1: Deactivated s...
well since it is in backup mode, I get:sub-aquatics#sh isdn statusGlobal ISDN Switchtype = basic-niISDN BRI0 interface dsl 0, interface ISDN Switchtype = basic-ni Layer 1 Status: DEACTIVATED Layer 2 Status: Layer 2 NOT Acti...
