Hi Jun Wen, I'm working with the IXM-LPWA-800-16-K9 LoRa gateway, where: The system version is:
Corsica Software, Version 2.0.11, RELEASE SOFTWARE
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2012-2014, 2017 by Cisco Systems, Inc.
Compiled 18-Sep-2017.16:19:04UTC-07:00 by Corsica Team
ROM: Bootstrap program is Corsica boot loader
Firmware Version : 2.0.11, RELEASE SOFTWARE
Bootloader Version: 20170515_cisco
cisco model: IXM-LPWA-800-16-K9
Processor : ARMv7 Processor rev 1 (v7l) with 1027308K bytes of memory.
The FPGA versione is:
INFO: SPI speed set to 2000000 Hz
checking FPGA version...
FPGA version: 58
HAL version: 5.0.0
SX1301 #0 version: 103
SX1301 #0 chip ID: 1
SX1301 #1 version: 103
SX1301 #1 chip ID: 1
##PASS: FPGA version check OK
The packet forwarder version is
PublicKeyStatus : Installed
FirmwareStatus : Installed
PacketFwdVersion : 1.8.19
LRRID : 68ba4729
PartnerID : 0001
If I perform the following command ( from configure terminal): packet-forwarder start or packet-forwarder restart I have a Radio issue.
17:46:21.404 (1825) [../lgw_x8.c:733] RADIO configured
17:46:21.404 (1825) [../lgw_x8.c:755] RADIO starting ...
17:46:21.404 (1825) [../lgw_x8.c:760] BOARD0 RADIO cannot be started ret=-1 'Invalid version number for the top FPGA'
So the packet forwarder doesn't start. How could I solve this issue? Regards.
... View more