Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My Pix is not forwarding to my Websense server, for URL filteringI worked with a tech from Websense, that assured me that the websense server is configured correctly. However I'm going to include some notes on it as well. The Websense server has two ...
I have 3 sites running 506e Pix's, with a private VPN tunnel setup between each. This is all fine, we can hit all of terminal servers from any inside location. I have remote access set to just my main location, so anyone needing to connect in from ...
We have a 506e, that has been up and running for about 2 years with no issues. This morning a janitor accidently pulled the either cable going from the Outgoing Port to the Router out of the PIX, then instead of pluging it back into the same port, t...
Part 2 of config:access-list inside_outbound_nat0_acl permit ip 192.168.1.0 255.255.255.0 Ligonier 255.255.0.0 access-list inside_outbound_nat0_acl permit ip 192.168.1.0 255.255.255.0 NTC2 255.255.255.0 access-list inside_outbound_nat0_acl permit ip ...
JorgeThanks for the help.I tried to console into the Pix, However after connecting, I was not able to get a prompt. I recieve no echoing responses back from hyper terminal, however it does show that it is connected.I do not know if this helps out or ...
