Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need a little expert knowledge involving the TX and RX settings on a 819HW. When I configure the antenna ports:#conf term(config)#int dot11 0(config-if)#antenna receive right left(config-if)#endAnd do a show run, I see the setting under the 'inter...
Scott,I now understand why I do not see the settings in 'show run' when they are defaulted. Thank you for explaining that.I also understand that diversity will dynamically choose which antenna to use dependent on signal quality, and I understand tha...
Scott,I really appreciate your feedback, but I guess I am not fully understanding your reply. Are you saying that programing the radio as 'antenna receive right left' is the same as 'antenna receive diversity', it is just a different way to achieve t...
IT is programing the radio with the exact phrase 'antenna receive right left' (they say they are directing the receive to both antennas, not just one - which they say is the same as diversity).When it is programed this way, a 'show run' gives under ...
Saurav,Thank you for your reply, but I don't feel that you fully understood my question. I am familiar with the options on the antenna settings (right only, left only, or diversity). My problem is:Our local IT guru is programing up the 819 radios w...
