Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have dusted off an old PIX 515e and want to use it to isolate our test lab. I erased the current configuration and then setup a test configuration with one wrkstn attached. I enabled dhcp and it is delivering address within the scope to the wrkst...
I have an old PIX 515E that was taken out of storage. We want to use it in the lab, but no one can remember the login name or password or IP. Is there a way to set to default and start over?
Michael, Thanks for the reply, sounds like I can't use ASDM. Looks like I am using PDM. Is there a GUI interface for my version? Below is my version from the PIX. Any additional info will be appreciated. Cisco PIX Firewall Version 6.3(3)Cisco PIX ...
