Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
ver Version 8.0(3)12ASA5510 inb active/standby configuration. Somewhere along the line I've lost telnet when failed over to the secondary unit. The firewall passes traffic and I can manage it from ASDM. Nmap shows the primary listening on port 23 but...
I'm scehdule dfor some training on the appliance next week. Meanwhile ..Does the appliance_need_to be managed via the Management interface? Can I run ASDM from the inside interface w/o issue? IOW, is there a good reason for providing the management i...
Failover looks good, and I've lost telnet on both the active and secondary units. Btw, I want to migrate to ssh in any case, once I figure this out;ssh 0 0 insidecrypto key gen rsabut I get a warning message;" you have a RSA keypair already defined n...
No can do. The secondary unit isn't listening on port 23, there aren't any log entries. As a matter of fact, I can't find any log entries for telnet on the primary unit. Let me look into that some more.
Thanks for the reply, I'll assign and IP and use the inside interface for management. I have to say e0/3 won't pass traffic since I can't see it to assign an IP address. I'll speculate that it's used for failover. We do have another 5100 with the fai...
