Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello, on a PIx 515when i try to apply the upgrade procedure i have this message :Received 2193408 bytesCisco Secure PIX Firewall admin loader (3.0) #0: Tue May 21 08:26:10 PDT 2002Flash=i28F640J5 @ 0x300BIOS Flash=AT29C257 @ 0xd8000An internal asser...
Thanks, when i try to apply the upgrade procedure i have this message :Received 2193408 bytesCisco Secure PIX Firewall admin loader (3.0) #0: Tue May 21 08:26:10 PDT 2002Flash=i28F640J5 @ 0x300BIOS Flash=AT29C257 @ 0xd8000An internal assertion check ...
hello thanks again for this explication, i managed to clear the password from the pix.BUT when it'e reboots, il start to load the config file and then crashes so that i can't type any command to clear my config file
hello, thanks for you information about the password recovery procedure, but the actual problem is that my device boots with 7.2.3 version of software and starts to proceed my configfile that was imported from V6.3 and the device crashes while proced...
hello, actually i can't log into my device because it crashes while proceding my config file :WARNING: The trustpoint will not be set for crypto map entry 'vers_partenaires3'> , sequence number 84, as there was already a pre-shared-key specified for ...
