Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 506E that hangs after displaying the PCI device table. After some research I found that this can be resolved by switching the internal jumper, and having done this the device now boots successfully and loads the config.I was hoping someone m...
Yes it should show the hit count, even if 0. The only thing that doesn't show a hit count is the object-group line as this is expanded below to show the indivdual entries.so (and forgive me if this misses the point) you may be looking at the wrong li...
Hello Kr,If you're using show access-list xxx and not seeing a hit count then the simple answer is likely to be that the packets are not matching the access-list entry.Is NAT involved? Perhaps the source or destination address is not as you would exp...
Hello John,According to Smahbub this can break your pix. If you have any other recourse then I would investigate those options first. Having said that I did some web-mining regarding the 506E and found that some posters reported that they had resolve...
