Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When i am trying to configure failvoer i am getting following error stating secondary state as failed. Please let me know where i went wrongDR-INT-FW# sh failoverFailover OnFailover unit PrimaryFailover LAN Interface: FAILOVER GigabitEthernet0/2 (up)...
Thanks mulhollandm for your reply.. as sought, below is show interface output.Interface GigabitEthernet0/2 "FAILOVER", is up, line protocol is up Hardware is i82546GB rev03, BW 1000 Mbps, DLY 10 usec Full-Duplex(Full-duplex), 1000 Mbps(1000 M...
