Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hii am trying to configure static nat for one address and as soon as i add the nat rule the internal host stops seeing the outside world. what have i forgotten to do? All help greatly appreciated, First timer!!
Hithanks for that. I have looked at the live viewer and it doesn't display any deny's etc. it does display the tear down on the particular NAT address. so this would say to me it is getting out but the response is not getting back in. I am not sure r...
hi the access-list inside_nat0_outbound extended permit ip 192.168.10.0 255.255.255.0 192.168.2.0 255.255.255.0 refers to the vpn tunel that is in place between the two networks.static ip address' from the .10 network can not access the outside world...
Ok the issue is I need to NAT a couple of address'. with it all configured as above the issue is as follows; the hosts that have the NAT address cannot access the outside network (internet) nor can the outside see the selected services that have been...
Thanks I also have dug this out if it helpsResult of the command: "sh running-config nat"nat (inside) 0 access-list inside_nat0_outboundnat (inside) 1 192.168.10.0 255.255.255.0All I need to do is set NAT for a couple of IP for a couple of services.t...
Hi thanks for your interest here you are.ASA Version 7.2(3) !hostname N***********domain-name d***********enable password xxxnames!interface Vlan1 nameif inside security-level 100 dhcp client update dns ip address 192.168.10.254 255.255.255.0 !interf...
