Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi , my vpn architecture is as follows:HQ using Cisco 1841 ISRStatic WAN IPLAN IP e.g. 192.168.1.0EasyVPN Server with Pre-share key configurations.Peer no.1Using dynamic IPDLink DSL-G600 seriesinstall cisco systems vpn clientthe questions:From the pe...
I'm want to build a Site-To-site VPN.HQ will using Cisco 1841 ISRHQ will be using registered PUBLIC IP.DSLBranch will be using Cisco 877 series ISRBranch will be using only dynamic IP provided by the country internet service provider.ADSLWhat approac...
hi farrukh ,i've come accross the online document abt the built in 'stateful firewall(Always On) feature that i can't comprehend.http://www.cisco.com/en/US/products/sw/secursw/ps2308/products_user_guide_chapter09186a008015ce82.html#95647http://help.u...
hi Farrukho-right, so lets say, after i allow the 'ports'of the peer's DLink router, any idea of of any useful 'commands' or 'utilities' i can use to test to verify if 'in-bound' traffic is working fine ?After I establish the ipsec tunnels using cisc...
Hi Farrukh,I understand you mean on the peer's Dlink router, I have to allow the UDP 500~4500 , ESP (IP Protocol #50) on the NAT gateway ?OrDo you mean on the HQ's cisco 1841 IOS configurations ?Thanks in advanceRick
Hi Jorge, I've been trying to create the 'sketch' , but I encounter problem regarding how to 'glue' the HQ VPN Head-end server to the 'peers'-ends to create a connectivity. The peers are using dynamic IPs , so how do I get over this obstacles ? Do I...
