Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How can I configure a 6509 switch with a FWSM to use an outside address of 10.1.1.1 and a inside address of 192.168.1.1? I would like to create a NAT that will resolve to several servers on the inside. How do you configure the inside and outside inte...
I had a simular issue, it ended up being the default gateway of my client system not being setup properly. Check the default gateway of the client, it should be the outside ip address.
