Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have an SCE solution running to provide packages and limits to internet consumption. I generated the "top P2P consumer" chart, it shows that consumers reached some volume above 50 Gig. The problem is that chart title says it's for only one d...
Hi,I tried to stop P2P programs by enabling all signatures of P2P. some programs were stopped like Kaza but may other programs like lime-wire and others were still working. I tried to modify the signatures to add ports of regex to it but I couldn't f...
Hi,Thanks for your responce.The case I'm telling is about the P2P top consumers. it shows subscrtibers P2P consumption that exceedes 60 Gig and also indicates a time span of only one day. this can't be right. so is this graph defected?Best regards.
Hi,by without success what do you mean exactly? did inside network access http and everything or inside network couldn't access any thing at all???Tha access list is right. you may check your NAT, Global configuration.B.Regards,Mohammed Moustafa.
Hi Dear,if the DHCP users are assigned ip address in the range 192.168.23.X and they are connected to the same lan with the servers, then it's not PIX problem as in this case users requests are sent to the servers directly not through the pix.recheck...
Hi,Like Mike says you can't cisco firewalls via telnetting to the outside interface. but there is a work around if you need it, you can raise the security level of the interface to 100 hence you can telnet to it.Please keep me updated with your case....
Dear,NAT is usually used for network structure hiding. if you have many steps doing NAT like ASA connected to routers or core switches that will also do NAT it's best practice to remove NAT from some of these stages to simplify network troubleshootin...
