Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am rather new to setting up firewalls. I have an ASA 5510 that I am setting up currently to block all non-web traffic on our firewall except from our office.I have configured the interfaces but when I run "show route" it only shows the inside route...
Jon,I am hosting a public website at on off-site colocation facility. We do have those address assigned and the website is running and accessible right now. I just have the uplink plugged into the backbone switch rather than the Firewall right now. P...
Thank you. That makes sense. As for why I couldn't get data to pass thru before I wanted to check and make sure my settings are right. My outside route should point to the gateway of the hosting company's router correct?Above I have listed my access...
It's actually disconnected right now. When we had connected it before we could ping it from the hosting company's router. Unfortunately the website is already live so I could not leave the outside interface connected after I failed to configure the f...
