About metrologic

metrologic · 07-17-2008

Let me prefix this by saying that I've been working with Cisco on this for 2 weeks to no avail. I have a 6 WAE Devices(5 WAE-612-K9's and 1 WAE-512-K9) out of which I can't seem to configure 1 WAE-612-K9 to work properly. To explain my configuratio...

metrologic · 07-23-2008

Ok I've figured this out. Thanks for your help Dan. It turned out to be IP Inspects on my router causing the issue. I didn't know that using an inline interface you still had to use the same router model as when you use WCCP redirection.

metrologic · 07-18-2008

Yes when I shut the inlinegroup everything works. We use the routers' CBAC / ACL firewall and no rules on the problematic side are any different from the others that work fine. We are on an MPLS connection. You can check out the sysreport at ftp:/...

metrologic · 07-18-2008

Yes, I still have the same issue. ICA/HTTPS/MAPI all fail with optimization turned on . Even with pass-thru enabled I still can't pass that traffic. I did an ethereal log and I'm getting invalid checksums and TCP resets on the following protocols:...

metrologic · 07-18-2008

I just upgraded all my WAE's to 4.0.19-b14

metrologic · 07-18-2008

Ok switching inline ports didn't work so I switched to my spare card, still doesn't work. I tried disabling EPM as well. Any thoughts?

Member Since	‎07-17-2008 05:26 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	7

User Statistics

User Activity

WAE-612-K9 Inline configuration not working

Re: WAE-612-K9 Inline configuration not working

Re: WAE-612-K9 Inline configuration not working

Re: WAE-612-K9 Inline configuration not working

Re: WAE-612-K9 Inline configuration not working

Re: WAE-612-K9 Inline configuration not working