Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I’m not a PIX expert but here is my suggestion. Be sure you aren’t trying to run NAT through your IPSec tunnel and that you are able to send data back and forth between the subnets. You should be able to accomplish this by adding a couple of NAT st...
Tauseef,All you should have to do is map a public IP Address with a static command to an internal private IP Address and then open up the terminal services port like you would for SMTP to that public IP Address. The answer you are looking for is por...
