Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I'm new to the community and hoping someone can shed some light on my issue. I have a leased line coming in to connect two sites, Right now I have an ASA 5508-X that I'm preparing to use for one site.
The sites are set up as follows:...
This is not a true mesh topology.
At this point I don't mind putting a router behind the ASA and handling the routing there. I was reading an article that appears to be appropriate:
http://wiki-see.info/wp/category/firewalsl/cisco-asa/page/2/
I w...
Right now I have a basic router attached directly to the leased line interface. I can ping from inside the asa over the leased line interface to the SiteA.
My explanation was a little confusing. Since SiteA and SiteB are connected via the leased li...
