Member since ‎01-16-2011

User Statistics

  • 14 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Replies

User Activity

Hello,I have a Cisco 2600 with IOS 12.3.  I need a very basic configuration to allow traffic between two LANs. To test this I cleared the router config to the factory default state and configured my network addresses on the interfaces.When I connecte...
Hello Experts,On my Pix515E ASDM console I quite often see large surges in the total number of connections. I would like to find a convenient way to see what (or who) is causing this.The command Show Local gives the answers but it returns details of ...
Hello,I am using a PIX515 to forward a block of public IP addresses to my end users inside. I use an inbound acl on the outside interface to control which services inside are accessible from the outside.As far as I can see there are two ways to overr...
Hello experts,I am trying to filter some outbound traffic but becoming confused!If  I have a network on the DMZ interface, eg, by default  the implicit rules allow all traffic on this network to the outside  interface but deny access t...
I am using a Pix 515 with IOS 8.0(3).I have in my access list on the outside interface...........access-list outside_access_in extended permit icmp any echo access-list outside_access_in extended permit icmp any 25...
Community Statistics
Member Since ‎01-16-2011 06:33 AM
Date Last Visited ‎11-01-2017 12:51 PM
Posts 14