Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello:
I am new to Cisco, pardon my little knowledge. I've acquired an ASA 5506-X with FIREPOWER and I've asked a friend to help configure it. We're not able to enter "enable-mode" when we connect to the console. We are using the USB port on the de...
Hi Marvin,
Is there a way I can setup ASDM on this device as it is (with the FTD image)? Tried to find some resource online without success.
Once again, thank you for your help.
Mwamba
Now that makes sense! And yes, I have FTD on this device. I understand that you mean this is by design. Is there a way to go around it? I must mention that at the moment I am not using the FTD features (I havent bought licenses for them - still debat...
Interestingly, there is no "enable" command on this device. I thought I was doing sometime wrong but a friend of mine checked it and saw the same thing. The only advanced mode I've seen is via the command "expert" which opens a prompt for bash comman...
