Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I need to clear an entry that appears in the FIB table of a context of our ACE module:# sh ip fib | inc 6.34x.y.6.34/32 N/A DROP V [0xc00](I masked the 2 first numbers of the IP address with x.y)This entry appeared after I...
Hello,We are using an ACE20 module running version A2(3.2).I have a question regarding IP stickyness and the timeout parameter.I found this in the "Server load balancing configuration guide" (in a section entitled: "Configuring a Timeout for IP Addre...
Hello,We want to run ASA 8.4.x on an old ASA5540. We need to upgrade its memory to 2 Gb with the following memory upgrade: ASA5540-MEM-2GB=I suspect that we will completely remove the existing 1 Gb of memory and replace it with 2 Gb. If this is the c...
Hello,The end of a "%ACE-6-302023 Teardown TCP connection ..." message is supposed to indicate the reason why the connection was torn down: TCP Fins, TCP Reset, Idle Timeout, etc. But i nour case some connections are logged with the following reason:...
Hello,We are using ANM 2.2 to manage our ACE modules running A2(2.2). I would like to upgrade our ACE modules to version A2(3.0). It was released on 12/Oct/2009 but ANM 2.2 still does not support it (although it does support A2(1.6a) which was publis...
Hi Kanwal,Thank you for your answer. I thought that maybe "clear rtcache" would do the trick...I checked and this entry was indeed replicated to the FT peer. If we reload the failover module first and wait until it's back in "standby hot" state befor...
Hello Varun,Thanks for your answer.Searching in the forums today I found this question from April 2011 which is very similar to my question. It is titled: "ASA5540, 5520, 5510 memory upgrade" by micoogullariThe answer is different and states that mem...
Hello Syed,I've been busy on other things but I finally had the time to test source-natting traffic from the real servers to a VIP in the same VLAN. I can't say that the solution is simple and elegant, but it works great!Thanks again for taking the t...
Hello again Syed,Thank you very much for your explanations, they were very clear. And it made me realize that the problem is not present in the whole context, but just on the same VLAN.In fact, I can now use a VServer from real servers located in ano...
Hello Syed,Thank you very much for the quick response! I looked at your sample configuration and it took me some time to understand it, probably because I used ANM to configure the ACE module and contexts, so I am not completely familiar with the CLI...
