Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a cisco 1921 router that I can not get to port forward/allow access to my internal webserver. SSH is open so it appears that the ISP or modem isn't blocking it (I could be wrong). Inside LAN works getting out to the internet. Gateway of last r...
No, when I only use the cisco, running my web server ad If I goto theexternal IP, i get page cant be displayed. I checked the ports withcanyouseeme.com port scanner and it says port 80 open. If I stop thewebserver, I get port 80 blocked.When i plug i...
Well I'm not sure it's routing. The modem gives very different ips.Someone else had stated the spectrum blocks ports on their end.With the last config i used my apache server. Can access it by lan.If i start the web server, the port scanner shows its...
I connected the modem to the router via switch, eliminating other netgear router. I verified i could ping all 3 devices in the switch. Router, server, laptop. All can communicate. I start my server, open the website canyouseeme.com. scan port ...
This whole thing is weird. How my setup is, I have Charter Spectrum a cable modem, connected to e1 on cisco router, e0 goes to netgear router, on this router, I can't enter any (0.0.0.0 0.0.0.0 route).When I put the Netgear N150 that was originally ...
