Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,Can someone check the attached file and see if something is wrong ?I need to be able to access the internet from inside, dmz and databse interfacesAnd most of all being able to have my port redirections working. on both outside and outside1 ...
Hi,I need to know if the following configuration is doable with the asa ?I have twp isp and each isp allocate a range of public IP. I have a database interface and a dmz and inside interface.What i need to do is to make all my databases and my server...
HiI need to fullfill the below configuration which is working fine on my actual D-Link Netdefend firewall.We have a range of IP assign by our ISP : 194.250.47.128/29194.250.47.129 is the firewall IP and 134 the isp gateway.We have 4 interfaces- The l...
Hi I'm neewbe in cisco asa configuration.we are running with a Dlink Netdefend Firewall and because of planning to install a oracle database we intend to migrate to cisco asa 5505 appliance.Our configuration is very simple but the oracle daabase is n...
Many thanks Maykol,For the outgoing i do agree that only the outside interface will be used.That is what we want to achieve.But for the incoming, we want to access the servers from both outside and outside1 iterface.So if my configuration works for t...
Hello,I sort out the issue.The configuration is running as expected.Need now to add the dual wan for inbound connections on second isp interface.Many thanks.
I encounter again an issue.If I try to nat 194.250.47.131 to 192.168.170.32 and 192.168.171.10 for www service, the firewall complains about overlapping issue.In my understanding that should not prevent the cisco to process the packets correctly to t...
Many thanks to both of you.If I get it right that means that I can connect both interface otuside1 and outside2 to my ISPs and select the default outbound route by using the lowest metric when specifying the default route on the static route part and...
